Troubleshooting en-us
43
Issue Cause and troubleshooting
A different error
code appears in the
display window.
E:01-00 to E:90-10
A technical fault is present.
1. Press .
2. Pull out the power cord plug of the appliance or
switch off the breaker.
3. Wait at least 2minutes.
4. Insert the power cord plug of the appliance in a
power outlet or switch on the breaker.
5. Switch the appliance on.
6. If the problem occurs again:
‒ Press .
‒ Turn off the water faucet.
‒ Pull out the power cord plug.
‒ Contact customer service →
Page53
and
give the error code.
Dishware is not dry. No rinse aid used or dosage set too low.
1.
Add Rinse aid →
Page24
.
2. Set the amount of rinse aid to be dispensed.
→
"Setting the amount of rinse aid", Page25
Cycle or cycle option has no drying phase, or dry-
ing phase is too short.
▶
Select a wash cycle with drying. →
Page15
Some option buttons decrease the drying re-
sult.
Water collects in recesses of dishware or silver-
ware.
▶
Position dishware at an angle where possible.
The combined detergent used has a poor drying
performance.
1. Use rinse aid to improve drying performance.
2. Use a different combined detergent with a bet-
ter drying performance.
Extra Dry not activated to improve drying perfor-
mance.
▶
Activate Extra Dry.
To Next Page
Loading...
