Bosch SGX78C55UC - Appliance Interior Wetness and Food Remnants

en-us Troubleshooting
46
Issue Cause and troubleshooting
Appliance interior
still wet after wash
cycle.
Not an error. Condensation drying creates water
droplets in the tub. This is normal. Moisture in the
air condenses on the inside walls of the appli-
ance, runs off, and is pumped out.
No action required.
Food remnants on
dishware.
Dishware was placed too close together or rack is
overfilled.
1. Arrange dishware with sufficient space in be-
tween.
The spray jets must reach the surfaces of the
dishware.
2. Avoid points of contact.
Spray arm rotation of the lower spray arm is
blocked.
▶ Arrange dishware so it does not obstruct spray
arm rotation.
Spray arm nozzles are blocked.
▶
Clean the Spray arms → Page41 .
Filters are dirty.
▶ Clean the filters.
→ "Cleaning filters", Page40
Filters are inserted incorrectly and/or not en-
gaged.
1. Insert the filters properly.
→ "Filter system", Page40
2. Twist filters into place.
Selected wash cycle is too light.
▶ Select a more intensive wash program.
Dishware has been precleaned too intensively.
Then the sensors choose a lighter cycle. Stub-
born remnants cannot be entirely removed.
▶ Only remove large remnants of food and do not
pre-rinse dishware.