8 9
ADJUSTING THE SETTINGS
1. Press the On/Off button. Hold down the selection buttons > and
START until the display shows E:x (x can be any number).
2. Release both buttons. Press the selection button > until the display
indicates the desired selection.
3. Press button < to choose the desired setting for that selection.
4. Press Start button to save the setting.
FREQUENTLY ASKED QUESTIONS
Q: Why is food left on dishes?
A: It is possible the dishes do not have adequate clearance between them.
Also, be sure nothing is blocking spray arm and that the filter is clean. Select an
intensive cleaning cycle.
Q: Why does the cycle run a long time?
A: 1. Sensors in the dishwasher automatically increase the cycle time to ensure a
good wash when heavy soil is detected.
2. Incoming water may not be hot enough and dishwasher has to heat it.
Q: Why is E:XX (X can be any number) displayed?
A: This is an error code. For example, E:22 indicates there is water in the sump
because the filter is blocked or needs cleaning. See the Use and Care Manual
for a list of error codes.
MAINTENANCE TIPS
Clean surfaces with damp cloth and mild soap.
NOTICE: Do not use abrasives or bleach based cleaners. Do not use stainless
steel cleaner on black stainless or anti-finger print surfaces.
Clean the filter 3-12 times a year, depending on usage.
1. Unscrew the Large Object Trap as illustrated and remove the entire filter
system.
2. Remove the micro-filter from the fine filter, rinse the filters under running
water clean with a soft brush.
3. Reinstall the filter system in reverse sequence, align arrows.
1
2
To access the full Use and Care Manual visit:
www.bosch-home.com/us/service/get-support/owner-manuals.
Type in the Model Number which can be found inside the dishwasher door:
Setting Factory setting Description
d-Intensive drying
d:00-d:01
d:00/ off Improved drying for glasses and
plastic, by increasing the tempera-
ture and length.
r-Rinse Aid
r:00-r:06
r:05 Dispenses the amount of rinse aid,
which affects drying (see above).
P-Auto power off
P:00-P:02
P:00/ unit does
not shut off
automatically
Unit turns itself off after cycle is
complete, either after 1 minute, P:01
or after 2 hours, P:02.
rE-Factory reset rE Restores the factory settings on the
dishwasher.
ADD RINSE AID
This dishwasher is designed to be used
with rinse aid, which enhances drying
results and shine.
Tip: Remove lid of the bottle for easier
pouring and avoid the air vent.
The amount of rinse aid dispensed can be
adjusted in the settings. Only change the
setting if streaks remain on the dishes (lower the amount), or if dishes are not
getting dry enough (increase the amount).
To Next Page
Loading...
