Problem Cause
Dishwasher
does not
start
Unit not reset or previous cycle not complet-
-
Dishwasher
beeping
(end of cycle
signal)
Display does
not illumi-
nate or con-
sole lights
are not on
A fuse may have been blown or circuit breaker
of the door, the display only illuminates when the door is
Check the fuse or circuit breaker box and replace the fuse
Ensure that door is properly latched and completely
Dishwasher
seems to run
-
Verify dishwasher is connected to hot water supply plumb-
Dishes aren’t
enough
Dishes are nested or loaded too close to-
Selected wash cycle is not suitable for food soil
Ensure that spray arm movement is not blocked by hand
Remove the spray arms and clean according to “Check/
Increase or decrease detergent depending on the water
Rearrange load such that water spray can reach all items in
Dishes are
dry enough
-
pletely as other items due to their inherent proper-
-
-
To Next Page
Loading...
