Table1 - RecommendedDetergentAmount
Heavy 45ml (3tbsp) 45ml (3tbsp) 25-45ml (1.75-3tbsp)
Auto 25-45ml (1.75-3tbsp) 25ml (1.75tbsp) 15-25ml (1-1.75tbsp)
Normal 25-45ml (1.75-3tbsp) 25ml (1.75tbsp) 15-25ml (1-1.75tbsp)
Speed60 TM 25ml (1.75tbsp) 15-25ml (1-1.75tbsp) 15ml (ltbsp)
Rinse None None None
Rinse Aid
Your dishwasher was designed to use rinse aid for best drying results. To
achieve proper drying, always use a liquid rinse aid, even if your deter-
gent contains a rinse aid or drying additive.
Note: The dishwasher indicates low rinse aid by turning on the "Add Rinse
Aid" indicator light. If this light is on, you need to refill the rinse aid dispenser
by following the directions below. If the light is not on, your dishwasher still
has enough Rinse Aid and there is no need to refill it.
Adding Rinse Aid
Add liquid rinse aid to the dispenser until it is
full (see Figure 9). Wipe up any excess rinse aid
that may puddle when the dispenser reservoir is
full. Lid must be snapped fully closed in order
to seal. The indicator light will go out a few
moments after the dishwasher door is shut.
See below for instructions on how to adjust the
amount of rinse aid dispensed.
Note: Setting the rinse aid to "r:O0" may increase
cycle times.
Figure 9
Setting the amount of rinse aid
The amount of rinse aid dispensed can be set from "r:00" to "r:06".
1 Press the [On/Off] button.
2 Hold down the "A" button (see page 15) and press [Start] until the
display indicates "d:00". Release both buttons.
3 Press the "A" button until the display shows "r:05".
4 Press the "C" button to select the desired setting.
"r:O0" = dispenser is OFF "r:04" = medium/high setting
"r:01" = lowest setting "r:05" = high setting
"r:02" = low setting "r:06" = highest setting
"r:03" = medium setting
5 Press [Start] to save the setting.
12
To Next Page
Loading...
