Child Lock (model dependent)
1 Start the desired cycle.
2 Hold down the button that says "Child Lock" underneath it for
approximately 4 seconds until the display reads "CL".
3 The "CL" will be indicated now if any button is pressed and the pro-
gram will not be reset.
To deactivate the child lock:
1 Hold down the "Child Lock" button for approximately 4 seconds until
the display no longer reads "CL".
Intensive Drying (model dependent)
The final rinse uses a higher temperature which improves the drying
results. The running time may increase slightly.
To turn intensive drying on:
1 Press the [On/Off] button.
2 Hold down the "A" button (see page 15) and press [Start] until the
display indicates "d:O0". Release both buttons.
3 Press the "C" button to turn intensive drying on or off. "d:01" = ON
and "d:O0" = OFF
4 Press [Start] to save setting.
Auto Power Off (model dependent)
To save energy, the dishwasher is turned off i minute after the wash cycle
ends. Auto Power Off can be adjusted from P:00 to P:02.
To change the factory setting (P:01):
1 Press the [On/Off] button.
2 Hold down the "A" button and press [Start] until the display indi-
cates "d:O0". Release both buttons.
3 Press the "A" button until the display indicates "P:O::[".
4 Press the "C" button until the display corresponds with your requirements.
P:O0 = dishwasher does not turn off automatically
P:O::I.(default) = dishwasher turns off automatically after 1 minute
P:02 = dishwasher turns off automatically after 120 minutes (2 hours)
5 Press [Start] to save the setting.
17
To Next Page
Loading...
