18
Auto Power Off
To save energy, the dishwasher is turned off 1 minute after the wash
cycle ends. Auto Power Off can be adjusted from P:00 to P:02.
To change the factory setting (P:01):
1 Press the [On/Off] button.
2 Hold down the “A” button and press [Start] until the display indi-
cates “d:00”. Release both buttons.
3 Press the “A” button until the display indicates “P:01”.
4 Press the “C” button until the display corresponds with your require-
ments.
P:00 = dishwasher does not turn off automatically
P:01 = dishwasher turns off automatically after 1 minute
P:02 = dishwasher turns off automatically after 120 minutes (2 hours)
5 Press [Start] to save the setting.
InfoLight® (model dependent)
An LED illuminates the floor to indicate the unit is running. If the appli-
ance is installed at eye-level, the LED is not visible.
To change the setting:
1 Open the door and press the [On/Off] button.
2 Hold down the “A” button and press [Start] until the display indi-
cates “d:00”.
3 Release both buttons.
4 Press the “A” button until the display shows “1:01”.
5 Press the “C” button to switch between “1:01” = ON and “1:00” =
OFF and press [Start] to save.
Language
To change the language of the display follow these instructions.
1 Open the door and press the [On/Off] button.
2 Hold down the “A” button and press [Start] until the display indi-
cates “d:00”.
3 Release both buttons.
4 Press the “A” button until the display shows “L:01”.
5 Press the “C” button until the display corresponds with your require-
ments.
L:02 = English
L:03 = French
L:07 = Spanish
6 Press [Start] to save and close the door.
To Next Page
Loading...
