Drain Hose
Use the hose clamp and rubber connection hose, item
"T" from accessory parts (see figure 2) to connect the
drain hose to the sink, disposer or air gap.
Hotwaterline
lectricsupplycable
Figure 10.
H_re 11.
The rear leveling leg is adjusted by turning the
center screw at the front of the dishwasher. The front
leveling legs are adjusted by rotating the front
leveling legs. See figure 11, above.
If additional height is needed:
Shims may be added under the leveler feet.
Figure 12.
The access hole for the drain hose should be 1.25" (32
mm) diameter.
Airgap f
Rubberconnector
Entrymustbe
abovetrap
Figure 13.
6
To Next Page
Loading...
