Bosch SHU43C05 - Turning off End of Cycle Tone

84
VIII.
VIII.
Troubleshooting
Troubleshooting
Control Module
Control Module
–
–
Using # 481055 Control Modules in Older
Using # 481055 Control Modules in Older
SHU 99 and SHV 43/48 Dishwashers (2)
SHU 99 and SHV 43/48 Dishwashers (2)
5
5
-
-
button pushbutton pad # 182600 used on SHV 48
button pushbutton pad # 182600 used on SHV 48
UC/06, UC/07, UC/11 & UC/12 and SHU 992x UC/12
UC/06, UC/07, UC/11 & UC/12 and SHU 992x UC/12
4
4
-
-
button pushbutton pad # 182605 used on SHV 43,
button pushbutton pad # 182605 used on SHV 43,
SHU 991x UC/06, UC/11 & UC/12 and SHU 990x UC/06
SHU 991x UC/06, UC/11 & UC/12 and SHU 990x UC/06
New pushbutton pads:
INSTRUCTIONS FOR TURNING OFF END OF CYCLE TONE:
 Open door, push and hold Delicate/Econo button, then turn
dishwasher on while holding Delicate/Econo button.
 Release Delicate/Econo button. If module beeps, then end of
cycle tone is on. Press Delicate/Econo button to disable tone.
If module doesn’t beep after button is pressed, then tone is
disabled.
 Turn off dishwasher to save selection.