Operating the Dishwasher en-us
35
Auto power off
To save energy, the dishwasher is
turned off 1 minute after the wash
cycle ends.
This setting can be adjusted from
˜:‹‹ to ˜:‹ƒ.
To change the setting:
1.
Open the door.
2.
Press On/Off button (.
3.
Hold down function key # and
press Start button P until the
display 8 indicates •:‹x (x can
be any number).
4.
Release both buttons.
The indicator of function key #
flashes and the display 8
indicates the factory set value
•:‹…
5.
Press function key # until the
display 8 indicates ˜:‹x.
6.
Press function key 3 until the
display corresponds with your
requirements.
7.
Press Start button P.
Switching off the appliance
Short time after the end of the wash
cycle:
1.
Open the door.
2.
Switch off On/Off button (.
3.
Turn off water supply.
4.
Remove the utensils when they
have cooled down.
9 WARNING
RISK OF INJURY!
To avoid risk of injury, always
use caution when opening the
door during or following a wash
cycle as hot water or steam
may escape. Do not fully open
the door until water noises have
stopped and steam has
subsided.
Interrupting the wash cycle
9 CAUTION
Expansion (overpressure) may
cause the appliance door to
open and/or water to escape! If
the door was opened on an
appliance which has a hot water
connection or is heated, always
leave the door ajar for several
minutes and then close.
1.
Open the door.
2.
Switch off On/Off switch (.
The LED’s go out. The wash cycle
is saved.
3.
To continue the wash cycle,
switch on the On/Off switch (
again.
4.
Close the door.
˜:‹‹ dishwasher does not turn off
automatically
˜:‹‚ dishwasher turns off
automatically after 1 minute
˜:‹ƒ dishwasher turns off
automatically after
120 minutes (2 hours)
To Next Page
Loading...
