Bosch SHX5AEM5N Quick Start And Safety Guide

6 Frequently Asked Questions
Q: Why is food remaining on dishes after I run the cycle?
• It is possible the dishes do not have adequate clearance between them. Also, be sure nothing is blocking the spray arms and
that the filter is clean. Select the Heavy cleaning cycle.
Q: Why does the cycle run a long time?
• Sensors in the dishwasher automatically increase the cycle time to ensure a good wash when heavy soil is detected.
• Incoming water may not be hot enough and dishwasher has to heat it.
Setting Factory setting Description
Rinse Aid
Off/Low/Medium/High
Medium Setting to adjust the amount of rinse aid
used in each cycle.
Intensive drying
Off/On
Off Setting to increase drying ability for glass-
es or plastic. Increases cycle length and
temperature.
End of cycle tone
Off/Low/Medium/High
Medium The volume of the tone signalling the end
of cycle.
5 Settings
5.1 Available Settings
Below are some commonly used settings. To see all the settings refer to the full online manual or go to Dishwasher » Settings in
the Home Connect
®
app.
5.2 Adjusting the settings
First Steps to adjust any setting:
Open the door and press the ON/OFF button.
Hold down Button A for 3 seconds, until the Rinse Aid
indicator light flashes.
Release button, then follow steps below to adjust specific
setting.
To adjust the rinse aid:
1. Press the Start button repeatedly until the right amount
of rinse aid has been set. 0 (off), 1(low), 2(medium),
or 3(high) LEDs above cycle buttons will light up
accordingly.
2. Press button A for 3 seconds to save the setting.
To turn on intensive drying:
1. Press button A until the Clean and Sanitize lights flash.
2. Press the Start button until 1 LED light above the heavy
cycle button is on (intensive dry is on).
3. Press button A for 3 seconds to save the setting.
To adjust the signal volume:
1. Press button A until the Clean and Rinse Aid lights flash.
2. Press the Start button repeatedly until the preferred
volume level has been selected. 0 (off), 1(low), 2(medi-
um), or 3(high) LEDs above cycle buttons will light up
accordingly.
3. Press button A for 3 seconds to save the setting.
To reset to factory settings:
1. Press button A until the Clean, Sanitize and Rinse Aid
lights flash.
2. Press the Start button. The 3 LEDs above cycle buttons
will blink alternatively for 1 minute. The factory settings
have been restored.
Tip: The simplest way to change the settings is with the
Home Connect
®
app.

Bosch SHX5AEM5N Specifications

General

Brand	Bosch
Model	SHX5AEM5N
Category	Dishwasher
Language	English