16
SHE4AV5#UC*
SHV4AT5#UC*
* # can be any number
NOTICE
NOTE: Buttons are sensitive and should be touched gently. Avoid any grease or food particles
resting on the buttons as they could activate the dishwasher. Wiping and cleaning can also
activate the dishwasher. For best results, use bare, clean hands when touching the buttons.
WARNING
WARNING
To avoid risk of injury (“burns”), always use caution when opening the door during or following a wash
cycle as hot water or steam may escape. Do not fully open the door until water noises have stopped
and steam has subsided.
Start the Dishwasher
1
Press the
[
On/Off]
button.
2 Select a cycle and desired options and press [Start].
NOTE: Your dishwasher is protected against unintentional operation. If the appliance door remains open for more than 4 seconds
after pressing the [Start/Resume] button, the operation will be paused. Press the [Start/Resume] button again and close the
appliance door.
Cancel a Cycle
1 Press and hold the [Start] button for approximately 3 seconds until the display reads “0:01”.
2 Wait about 1 minute while the dishwasher drains.
3 Press the [On/Off] button.
NOTE: Your dishwasher is protected against unintentional operation. If the appliance door remains open for more than 4 seconds
after pressing the [Start/Resume] button, the operation will be paused. Press the [Start/Resume] button again and close the
appliance door.
Interrupt a Cycle
1 Press the [On/Off] button to turn the unit off.
2 To resume the cycle, press the [On/Off] button.
NOTE: Your dishwasher is protected against unintentional operation. If the appliance door remains open for more than 4 seconds
after pressing the [Start/Resume] button, the operation will be paused. Press the [Start/Resume] button again and close the appli-
ance door.
To Next Page
Loading...
Need help?
General
