To Next PageTo Next Page
Need help?Do you have a question about the Bosch SHX46A05 and is the answer not in the manual?
General| Brand | Bosch |
|---|---|
| Model | SHX46A05 |
| Category | Dishwasher |
| Language | English |
Explains the meaning of warning symbols, including injury or death risks.
Lists potential hazards like electrical shock and sharp edges.
Warns about electric shock and emphasizes power disconnection and grounding.
Details property damage risks, primarily from improper water connections.
Notes that no PC boards are handled directly in dishwasher repairs.
Confirms no CFCs or refrigerants used; mentions occasional drain smells.
States no carbon monoxide is emitted and no government compliance issues.
Lists UL certification and Energy Star certification for energy savings.
Details electrical ratings, water pressure, and motor specifications.
Explains the current and older model number formats and their components.
Shows where the serial label with model and factory information is located.
Indicates that wiring and circuit diagrams are found folded in the dishwasher base.
Outlines various warranty periods including limited lifetime and specific component coverage.
References separate instructions for location, electrical, water/drain, and shipping.
Details steps like leveling cabinets and doors, handle installation, and door reversal.
Lists top ten cosmetic, use, and installation problems and their causes.
Provides comprehensive guidance on installation procedures and warnings.
Explains the use of separate pumps, flow-through heaters, and condensation drying.
Covers triple filter methods, aqua sensors, and water spray levels.
Describes normal water fill levels and overfill protection mechanisms.
Defines key components like circulation pumps, NTC sensors, and control modules.
Explains the operation of the detergent and rinse-aid dispenser.
Describes the actuator system for diverting water to the top rack.
Distinguishes between mechanical and electronic door latch systems.
Details how aqua sensors impact energy and water usage by adjusting cycles.
Explains how water fill assemblies ensure proper dishwashers fill at various pressures.
Details accessing water valves and identifies different valve part numbers.
Guides on accessing, removing, and disassembling circulation pumps.
Provides procedures for accessing and replacing various control modules.
Details accessing and replacing heater assemblies and NTC sensors.
Explains how to remove and install drain pumps, including sump improvements.
Guides on removing and installing dispensers and their top-load variants.
Details removal, installation, and alignment procedures for door latches.
Explains how to access aqua sensors and water fill assemblies.
Lists models and button sequences to enter diagnostic test programs.
Lists and explains various test program and customer error codes.
Details how to measure resistances of heater and NTC components using test programs.
Table of common problems, causes, and suggested actions for washability and drying.
Discusses common problems related to specific parts like valves, pumps, and modules.
Covers impeller issues, PTC starter checks, nuisance tripping, and part changes.
Addresses heater relays, button replacement, model upgrades, and wiring issues.
Covers replacing older heaters and issues with water switch flow control.
Details sump improvements, dispenser door replacement, and top-load dispenser.
Guides on realigning and correcting miswired door latches.
Describes larger terminal boxes and their rear conduit exits.
Provides resistance values for various components at control modules for different models.
Presents detailed wiring diagrams for various SHU, SHI, SHV, SHX, SHY models.
