8
START YOUR DISHWASHER
1. Press the On/O button.
2. Select a cycle and option if desired.
3. Press Start.
ADJUSTING THE SETTINGS
1. Press the On/O button. Hold down button A (see pages 6-7) and press
Start until the display shows š:‹x (x can be any number).
2. Release both buttons. The LED for the button A ashes and the digital
display shows the factory set value. Press A to choose the setting.
3. Press buttons B or C (up or down) to change the setting.
4. Press Start button to save the setting.
Setting Factory setting Description
š-Intensive drying
š:‹‹-š:‹‚
š:‹‹/ o Improved drying for glasses and
plastic, by increasing the tempera-
ture and length.
§-Rinse Aid
§:‹†-§:‹‡
§:‹† Dispenses the amount of rinse aid,
which aects drying (see above).
›-Beep at cycle
end
›:‹‹-›:‹„
›:‹ƒ
Adjust the sound level of the signal
beep at the end of the cycle. Or turn
o (›:‹‹).
‚ -Info light
‚:‹‹-‚:‹‚
‚:‹‚ / on Light projected on the oor to signal
active wash cycle. Set to on or o.
˜-Auto power o
˜:‹‹-˜:‹ƒ
˜:‹‹/ unit does
not shut o
automatically
Unit turns itself o after cycle is com-
plete, either after 1 minute, ˜:‹‚ or
after 2 hours, ˜:‹ƒ.
ADD RINSE AID
This dishwasher is designed to be used
with rinse aid, which enhances drying
results and shine.
• Add rinse aid before rst use and when
the Add Rinse Aid indicator light on the
control panel illuminates.
• Lift tab to open the rinse aid reservoir
and add liquid rinse aid into the oval
until it is full, avoiding air vent. Wipe up
any excess rinse aid that may puddle.
Tip: Remove lid of rinse aid bottle for easier pouring.
The amount of rinse aid dispensed can be set in 6 levels. Only change the
setting if streaks remain on the dishes (lower the amount), or if dishes are not
getting dry enough (increase the amount).
9001490758.MV.indd 8 11/5/2019 11:23:23 AM
To Next Page
Loading...
Need help?
General
