en-us Operating the Dishwasher
34
Switching off the appliance
Short time after the end of the wash
cycle:
1.
Press On/Off button (.
2.
Remove the dishes when they
have cooled down.
9 WARNING
RISK OF INJURY!
To avoid risk of injury, always
use caution when opening the
door during or following a wash
cycle as hot water or steam
may escape. Do not fully open
the door until water noises have
stopped and steam has
subsided.
Interrupting the wash cycle
9 CAUTION
Expansion (overpressure) may
cause the appliance door to
open and/or water to escape! If
the door was opened on an
appliance which has a hot water
connection or is heated, always
leave the door ajar for several
minutes and then close.
1.
Press On/Off button (.
The LED’s go out. The wash cycle
is saved.
2.
To continue the wash cycle, close
the door and press On/Off button
( again.
Note: Your dishwasher is protected
against unintentional operation. If the
appliance door remains open for
more than 4 seconds after pressing
the Start button, the operation will be
paused. Close the appliance door
and press the Start button P again.
Terminating the wash cycle
(Reset)
Ter minating the wa s h cycl e
1.
Press and hold Start button P
for approximately 3 seconds until
the display reads ‹:‹‚.
2.
Wait about 1 minute while the
dishwasher drains.
3.
Press On/Off button (.
You may now power the dishwasher
back on and begin a new cycle if
desired.
Changing the wash cycle
When the Start button ( has been
pressed, the wash cycle cannot be
changed. The only way a wash cycle
can be changed is by terminating the
wash cycle (Reset).
To Next Page
Loading...
Need help?
General
