20
Cycle Completion Signal
1 Open the door and press the [On/Off] button.
2 Hold down the “A” button (see page 18) and press [Start] until the
display indicates “d:00”. Release both buttons.
3 Press the “A” button until the display shows “b:02”.
4 Press the “C” button to increase or decrease the tone “b:00” = OFF
and “b:03” = LOUDEST and press [Start] to save setting and close
the door.
Auto Power Off
To save energy, the dishwasher is turned off 1 minute after the wash
cycle ends. This setting can be adjusted from P:00 to P:02.
To change the setting:
1 Open the door and press the [On/Off] button.
2 Hold down the “A” button and press [Start] until the display indi-
cates “d:0x” (x can be any number). Release both buttons.
3 Press the “A” button until the display indicates “P:0x”.
4 Press the “C” button until the display corresponds with your require-
ments.
P:00 = dishwasher does not turn off automatically
P:01 = dishwasher turns off automatically after 1 minute
P:02 = dishwasher turns off automatically after 120 minutes (2 hours)
5 Press [Start] to save the setting.
InfoLight®
An LED illuminates the floor to indicate the unit is running. If the appliance is
installed at eye-level, the LED is not visible.
To change the setting:
1 Open the door and press the [On/Off] button.
2 Hold down the “A” button and press [Start] until the display indicates
“d:00”.
3 Release both buttons.
4 Press the “A” button until the display shows “1:01”.
5 Press the “C” button to switch between “1:01” = ON and “1:00” = OFF
and press [Start] to save.
Aquastop® Leak Protection
Our AquaStop® system contains leaks through a precisely engineered tub
and sensor system that works with our solid molded base. If a leak has
occurred, it shuts down operation and automatically pumps out water to
avoid contact with the floor. It works 24/7 and can turn itself on.
To Next Page
Loading...
