Bosch SM SERIES - User Manual

Bosch SM SERIES

68 pages

Save Page as PDF

To Next Page

To Next Page

Loading...

Register your

new device on

MyBosch now and

get free benefits:

bosch-home.com/

welcome

Dishwasher

SM... SB...

[en] User manual

Table of Contents

Other manuals for Bosch SM SERIES

Installation, Operation And Maintenance Manual36 pages

Instructions64 pages

Instruction Manual56 pages

Instructions For Use68 pages

Questions and Answers

W
williamsisaacAug 5, 2025
What to do if my Bosch Air Handler unit is off due to high-pressure control?
- J
  James SpearsAug 5, 2025
  If your Bosch Air Handler shuts off due to high-pressure control, consider these potential causes: * **High Discharge Pressure:** If in 'COOLING' mode, check for lack of or inadequate water flow, excessively warm entering water temperature, or a scaled/plugged condenser. If in 'HEATING' mode, check for lack of or inadequate load-side fluid flow, an inoperative blower, a clogged filter, or ductwork restrictions. * **Refrigerant Overcharge:** The unit may be overcharged with refrigerant. If this is the case, reclaim refrigerant, evacuate, and recharge with the factory-recommended charge. * **High-Pressure Switch:** Inspect the high-pressure switch for defects or improper calibration.
D
Donna ShepardAug 15, 2025
What to do if my Bosch Air Handler unit is short cycling?
- C
  clynchAug 16, 2025
  If your Bosch Air Handler is short cycling, here are some things to check: * **Unit Size:** The unit might be oversized. Recalculate the heating and/or cooling loads. * **Thermostat Placement:** If the thermostat is near a supply air grill, relocate it. Also, adjust the heat anticipator. * **Wiring and Controls:** Check for a defective or improperly calibrated low-pressure switch.
J
Jennifer FigueroaAug 20, 2025
What to do if my Bosch Air Handler unit is off due to low-pressure control?
- M
  Mrs. Amanda CarpenterAug 20, 2025
  If your Bosch Air Handler shuts down due to low-pressure control, consider these possible reasons: * **Low Suction Pressure:** If in 'COOLING' mode, check for lack of or inadequate airflow, too cold entering air temperature, an inoperative blower, a clogged filter, or ductwork restrictions. If in 'HEATING' mode, check for lack of or inadequate water flow, too cold entering water temperature, or a scaled/plugged condenser. * **Low Refrigerant Charge:** The unit may be low on refrigerant. Check for refrigerant leaks, repair them, evacuate the system, and recharge it with the factory-recommended charge. * **Low-Pressure Switch:** Inspect the low-pressure switch for defects or improper calibration.
M
mayoseanOct 26, 2025
What to do if my Bosch Air Handler unit does not run?
- P
  pearsoncynthiaOct 26, 2025
  If your Bosch Air Handler unit isn't running, there are several potential causes: * **Power Supply:** Ensure the disconnect is closed and power is applied. * **Blown Fuse/Tripped Breaker:** Replace any blown fuses or reset tripped circuit breakers, ensuring fuses are the correct size. * **Low Voltage Supply:** If the voltage is below the minimum specified on the unit's data plate, contact your local power company. * **Thermostat:** Set the fan to 'ON' to see if the fan runs. Set the thermostat to 'COOL' with the lowest temperature, the unit should run in cooling mode. Set it to 'HEAT' with the highest temperature; the unit should run in heating mode. If nothing happens, the thermostat might be miswired or faulty. Check for 24 volts between 'R' and 'C,' 'Y' and 'C,' and 'O' and 'C'...
D
Diana HollowayOct 30, 2025
Why is my Bosch Air Handler providing insufficient cooling or heating?
- R
  Rachel BanksOct 31, 2025
  Several factors can cause insufficient cooling or heating in your Bosch Air Handler: * **Unit Size:** The unit might be undersized; recalculate heating and cooling loads and consider adding insulation and shading. * **Air Leaks:** Check for leaks in ductwork or ambient air entering through doors or windows. * **Airflow Issues:** Ensure adequate airflow and proper air distribution. Replace any dirty filters. * **Refrigerant Charge:** Low refrigerant charge can cause inefficient operation. * **Compressor Problems:** A defective compressor may not pump properly. Check if the discharge is too low and suction pressure is too high. If so, replace the compressor. * **Reversing Valve Issues:** A defective reversing valve can cause refrigerant bypass. Consider replacing it. * **Opera...
C
Colton TorresNov 10, 2025
What to do if the blower operates but the compressor does not in my Bosch Air Handlers?
- J
  Jeremy BrooksNov 10, 2025
  If the blower in your Bosch Air Handler is running, but the compressor isn't, check the following: * **Thermostat:** Verify the thermostat's settings, calibration, and wiring. * **Wiring:** Look for loose or broken wires at the compressor, capacitor, or contactor. * **Safety Controls:** Check the UPM board red default L.E.D. for a Blink Code. * **Compressor Overload:** If the compressor is cool and the overload won't reset, replace the compressor. * **Compressor Motor Grounded:** If the internal winding is grounded to the compressor shell, replace the compressor. Install a suction filter dryer if the compressor is burnt out. * **Compressor Windings Open:** After the compressor cools, check the continuity of the compressor windings. If the windings are open, replace the compres...

Summary

Dishwasher User Manual

Safety

Safe Installation Warnings

Details risks and precautions for safe appliance installation, including electrical safety.

Safe Use Warnings

Covers safety instructions for using the appliance, including health and burn risks.

Child Safety Precautions

Highlights risks to children, including suffocation, crushing, and chemical exposure.

Damaged Appliance Handling

Preventing Material Damage

Installation and Connection

Water and Electrical Connections

Details on connecting drainage, drinking water, and electricity supplies.

Initial Setup, Settings, and Connectivity

Basic Settings and Home Connect

Covers configuring basic appliance settings and connecting to a home network.

Basic Operation

Programme Management and Features

Covers setting additional functions, timer programming, starting, interrupting, and terminating.

Troubleshooting

Safety and Error Code Resolution

Addresses appliance safety, error codes, fault displays, and signal indicators.

Washing Result Issues

Provides solutions for common washing problems like dry tableware or food remnants.

Operational and Connectivity Problems

Bosch SM SERIES Specifications

General

Brand	Bosch
Series	SM SERIES
Category	Dishwasher
dBA	44
Water Filtration System	Yes
Third Rack	No
Noise Level	44 dB
Delay Start	Yes
Half Load Option	No
Child Lock	Yes

Related product manuals

Preview: Bosch SHI66A