Bosch SMI2ITS33E - Before Using for the First Time; Performing the Initial Configuration; Water Softening System

en Before using for the first time
22
1
2
2. To use the prongs again, fold them
back up.
a The prongs audibly click into posi-
tion.
Basket heights
Set the baskets at the right height.
Appliance height 81.5cm with cutlery basket
Setting Top basket Bottom basket
1 max. ø 22 cm 31 cm
2 max. ø 24.5 cm 27.5 cm
3 max. ø 27 cm 25 cm
Before using for the first time
Before using for the
first time
Before using for the first time
Configure the settings for initial start-
up.
Performing the initial config-
uration
On initial start-up or after a reset to
the factory settings, you will need to
make settings.
Tip:Connect your appliance to a mo-
bile device. You can conveniently
change all settings via the
HomeConnect app.
→"HomeConnect quick start",
Page35
Requirement:"The appliance has
been installed and connected."
→Page12
1.
"Add special salt." →Page23
2.
"Add rinse aid." →Page25
3. "Switch on the appliance."
→Page30
4. "Setting the water softening sys-
tem." →Page23
5. "Set the amount of rinse aid to be
dispensed." →Page26
Tip:You can change these settings
and other "Basic settings"
→Page33 at any time.
Water softening system
Water softening system
Water softening system
Hard water leaves limescale on the
tableware as well as the washing
tank and parts of the appliance may
become blocked.
To ensure good dishwashing results,
you can treat the water with special
salt and the water softening system.