Bosch SMS2ITW41G Information For Use

en Rinse aid system
26
¡ The water hardness is 0 - 8°E.
You do not need to use special
salt.
1. Press ⁠.
2. To open the basic settings, press
for 3 seconds.
a The display shows Hxx.
a The display shows ⁠.
3. Press repeatedly until the dis-
play shows H00.
4. To save the settings, press
for 3 seconds.
a The water softening system is
switched off and the salt refill indic-
ator is deactivated.
10.5 Regeneration of the wa-
ter softening system
In order to obtain fault-free function of
the water softening system, the appli-
ance performs regeneration of the
water softening system at regular in-
tervals.
Regeneration of the water softening
system takes place before the end of
the main rinse cycle in all pro-
grammes. It will increase the run time
and consumption values, e.g. water
and electricity.
Overview of consumption values
with regeneration the water
softening system
Here you can find an overview of the
maximum additional running time and
consumption values during regenera-
tion of the water softening system.
Regeneration of the water
softening system after x
washing programmes
5
Additional running time in
minutes
7
Additional water consump-
tion in litres
5
Additional power consump-
tion in kWh
0.05
The consumption values specified
are laboratory measurements determ-
ined in accordance with the currently
applicable standard using the Eco
50° programme and with the factory
value of the water hardness set to 16
- 20°E.
Rinse aid system
11 Rinse aid system
Rinse aid system
11.1 Rinse aid
For optimum drying results, use rinse
aid.
Only use rinse aid for domestic dish-
washers.
Adding rinse aid
If the rinse aid refill indicator lights
up, top up with rinse aid. Only use
rinse aid for domestic dishwashers.
1. Press the catch on the lid of the
dispenser for rinse aid and lift
⁠.
1
2

Bosch SMS2ITW41G Specifications

General

Brand	Bosch
Model	SMS2ITW41G
Category	Dishwasher
Language	English