Bosch SMS4ECI26E/13 - Home Connect Problem; Information on Display Panel

Troubleshooting en
53
Fault Cause Troubleshooting
Excessive formation of foam
occurs.
Detergent or appliance care
product used causes excess-
ive foaming.
▶ Change the brand of detergent.
Home Connect problem
Fault Cause Troubleshooting
Connection to home net-
work is not established.
WLAN on router is not act-
ive.
▶ Check the wireless network con-
nection of your router.
WLAN display is flashing. Connection to home net-
work is not available.
▶ Activate the wireless network con-
nection on your router.
Home Connect cannot be
implemented correctly.
Home Connect set incor-
rectly.
▶ Please consult the documents sup-
plied for HomeConnect.
Technical fault is present. ▶ Please consult the information
about support in the documents
supplied for HomeConnect.
Information on display panel
Fault Cause Troubleshooting
Special salt refill indicator
lights up.
Insufficient special salt. ▶ Add "Special salt" →Page25.
Sensor does not detect spe-
cial salt tablets.
▶ Do not use special salt tablets.
Refill indicator for special
salt does not light up.
Water softening system is
switched off.
▶ Setting the water softening system
Refill indicator for rinse aid
lights up.
Insufficient rinse aid. 1. Add "Rinse aid" →Page27.
2. Set the amount of rinse aid to be
dispensed.
→"Setting the amount of rinse aid",
Page27
Refill indicator for rinse aid
does not light up.
Rinse aid system is switched
off.
▶ Set the amount of rinse aid to be
dispensed.
Display flashes. Appliance door is not closed
properly.
▶ Close the appliance door.
‒ Arrange the tableware so
that no parts project beyond
the basket and prevent the
appliance door from closing
properly.