Bosch SMS4EMC06E - Cutlery Drawer; Before Using for the First Time; Performing the Initial Config- Uration

first time en
25
1. Push the lever forwards and fold
down the prongs ⁠.
1
2
2. To use the prongs again, fold them
back up.
a The prongs audibly click into posi-
tion.
8.5 Cutlery drawer
Arrange cutlery in the cutlery drawer.
Arrange cutlery with the points and
sharp edges downwards.
first time
9 Before using for the
first time
first time
9.1 Performing the initial con-
figuration
On initial start-up or after a reset to
the factory settings, you will need to
make settings.
Tip:Connect your appliance to a mo-
bile device. You can conveniently
change all settings via the
HomeConnect app.
Requirement:The appliance has
been installed and connected.
→Page11
1.
Add special salt. →Page27
2.
Add rinse aid. →Page28
3. Switch on the appliance.
→Page34
4. Setting the water softening system.
→Page26
5. Set the amount of rinse aid to be
dispensed. →Page29
6.
Add detergent →Page29.
7. Start the Programme with the
highest cleaning temperature
without tableware.
To remove any marks from water
or other residues, we recommend
you operate the appliance without
tableware before using it for the
first time.
Tip:You can change these settings
and other Basic settings →Page37
at any time.