Bosch SMS6ECI11E - 9 Before Using for the First Time; Performing the Initial Config- Uration

Before using for the first time en
25
2. Pull the tab on the Extra Clean
Zone up and forwards ⁠.
3. Set the slider to ON.
4. Clean under running water.
5. Place the Extra Clean Zone in the
top basket and lock in place ⁠.
Check that the mounts are in the
correct position.
a The Extra Clean Zone audibly
clicks into position ⁠.
6. Push in the top basket.
Before using for the first time
9 Before using for the
first time
Before using for the first time
9.1 Performing the initial con-
figuration
On initial start-up or after a reset to
the factory settings, you will need to
make settings.
Tip:Connect your appliance to a mo-
bile device. You can conveniently
change all settings via the
HomeConnect app.
Requirement:The appliance has
been installed and connected.
→Page11
1.
Add special salt. →Page27
2.
Add rinse aid. →Page28
3. Switch on the appliance.
→Page34
4. Setting the water softening system.
→Page26
5. Set the amount of rinse aid to be
dispensed. →Page29
6.
Add detergent →Page29.
7. Start the Programme with the
highest cleaning temperature
without tableware.
To remove any marks from water
or other residues, we recommend
you operate the appliance without
tableware before using it for the
first time.
Tip:You can change these settings
and other Basic settings →Page36
at any time.