Bosch SMU2ITW04S - Customizing Appliance Settings; Wi-Fi and Remote Start Setup; Home Connect Introduction and Requirements

en HomeConnect
34
3. Press repeatedly until
and flash in the display.
4. Press repeatedly until the
LEDs show the right value.
If "LED A" →Page16 is not lit, Ex-
tra Dry is switched off.
If "LED A" →Page16 is lit, Extra
Dry is switched on.
5. To save the settings, press
for 3 seconds.
Set Wi-Fi
1. Press ⁠.
2. To open the appliance settings,
press for 3 seconds.
a flashes in the display.
3. Press repeatedly until
and flash in the display.
4. Press repeatedly until the
LEDs show the right value.
If "LED A" →Page16 is not lit, the
wireless network connection is
switched off.
If "LED A" →Page16 is lit, the
wireless network connection is
switched on.
5. To save the settings, press
for 3 seconds.
Activating Remote Start
1. Press ⁠.
2. To open the appliance settings,
press for 3 seconds.
a flashes in the display.
3. Press repeatedly until
flashes on the display.
4. Press repeatedly until the
LEDs show the right value.
If LED A lights up, the function is
permanently deactivated.
If LED A and LED B light up, the
function can be selected using the
button.
If LED A, LED B and LED C light
up, the function is permanently ac-
tivated.
The factory setting is level 2 ("LED
A and LED B" →Page16).
5. To save the settings, press
for 3 seconds.
Restoring factory settings
1. Press ⁠.
2. To open the appliance settings,
press for 3 seconds.
a flashes in the display.
3. Press repeatedly until ,
and flash in the display.
4. Press to set the appliance
back to the factory settings.
a The appliance is reset.
HomeConnect
HomeConnect
HomeConnect
This appliance is network-capable.
Connect your appliance to a mobile
device to control its functions via the
HomeConnect app.
The HomeConnect services are not
available in every country. The avail-
ability of the HomeConnect function
depends on the availability of
HomeConnect services in your coun-
try. You can find information about
this at: www.home-connect.com.
To be able to use HomeConnect,
you must first set up the connection
to the WLAN home network (Wi-Fi
1
)
and to the HomeConnect app.
¡ →"Connecting the appliance to
WLAN home network (Wi-Fi)",
Page35
The HomeConnect app guides you
through the entire login process. Fol-
low the instructions in the HomeCon-
nect app to configure the settings.
1
Wi-Fi is a registered trademark of the Wi-Fi Alliance.