Bosch SMV2HAX02E - Setting Up Wi-Fi Connection; Configuring Remote Start

Basic settings en
35
Setting Extra Dry
1. Press ⁠.
2. To open the appliance settings,
press for 3 seconds.
a flashes in the display.
3. Press repeatedly until
and flash in the display.
4. Press repeatedly until the
LEDs show the right value.
If LED A →Page16 is not lit, Extra
Dry is switched off.
If LED A →Page16 is lit, Extra Dry
is switched on.
5. To save the settings, press
for 3 seconds.
Setting signal volume
1. Press ⁠.
2. To open the appliance settings,
press for 3 seconds.
a flashes in the display.
3. Press repeatedly until
and flash in the display.
4. Press repeatedly until the
right signal volume has been set.
0, 1, 2 or 3 LEDs will light up ac-
cordingly. The signal tone selected
will be heard.
The factory setting is level 2 (LED
A and LED B →Page16).
5. To save the settings, press
for 3 seconds.
Set Wi-Fi
1. Press ⁠.
2. To open the appliance settings,
press for 3 seconds.
a flashes in the display.
3. Press repeatedly until
and flash in the display.
4. Press repeatedly until the
LEDs show the right value.
If LED A →Page16 is not lit, the
wireless network connection is
switched off.
If LED A →Page16 is lit, the wire-
less network connection is
switched on.
5. To save the settings, press
for 3 seconds.
Set remote start
1. Press ⁠.
2. To open the appliance settings,
press for 3 seconds.
a flashes in the display.
3. Press repeatedly until
flashes in the display.
4. Press repeatedly until the
LEDs show the right value.
If LED A is lit, remote start is per-
manently deactivated.
If LED A and B LED are lit, remote
start can be selected via the re-
mote start button.
If LED A, LED B and LED C are lit,
remote start is permanently activ-
ated.
The factory setting is level 2 (LED
A and LED B →Page16).
5. To save the settings, press
for 3 seconds.
Restoring factory settings
1. Press ⁠.
2. To open the appliance settings,
press for 3 seconds.
a flashes in the display.
3. Press repeatedly until ,
and flash in the display.
4. Press to set the appliance
back to the factory settings.
a The appliance is reset.