Bosch SMV4HCX58E - Changing Basic Settings; Remote Start, Page

en Basic settings
36
Basic setting Display text Selection Description
InfoLight I01
1
I00 - I01 Switch InfoLight on or off.
While the programme is running, a
spot of light is projected onto the
floor below the appliance door. This
light will not be visible if the appli-
ance is installed at eye level with the
cabinet front fitted flush. If the appli-
ance door is not completely closed,
the spot of light will flash. The pro-
gramme has ended when the spot of
light is no longer visible on the floor.
Level "I00" switches InfoLightoff.
Tone volume b02
1
b00 - b03 Adjustment of tone volume.
Level "b00" switches the signal tone
off.
Wi-Fi Cn0
1
Cn0 - Cn1 Switch the wireless network connec-
tion on or off.
Level "Cn0" switches the wireless
network connection off.
Remote Start rc1
1
rc0 - rc2 Activate or deactivate
→"Remote Start ", Page38.
The following settings are possible:
¡ With the setting "rc0", the func-
tion is permanently deactivated.
¡ With the setting "rc1", the func-
tion can be selected via the
button.
→"Activating Remote Start ",
Page38
¡ With the setting "rc2", the func-
tion is permanently activated.
Factory setting rE Start with
YES
Confirm with
Restore changed settings to the fact-
ory settings.
The settings for initial start-up must
be configured.
1
Factory setting (may vary according to model)
Changing basic settings
1. Open the appliance door.
2. Press ⁠.
3. To open the basic settings, press
for 3 seconds.
a The display shows Hxx.
a The display shows ⁠.
4. Press repeatedly until
the display shows the required set-
ting.
5. Press repeatedly until the dis-
play shows the right value.
You can change several settings.