Bosch SMV6ZCX49E - Appliance Settings and Home Connect; Changing Basic Settings Procedure; Home Connect Setup Process

HomeConnect en
39
Basic setting Display text Selection Description
Remote Start rc:01
1
rc:00 - rc:02 Activate or deactivate
→"Remote Start ", Page40.
The following settings are possible:
¡ With the setting "rc:00", the func-
tion is permanently deactivated.
¡ With the setting "rc:01", the func-
tion can be selected via the
button.
→"Activating Remote Start ",
Page40
¡ With the setting "rc:02", the func-
tion is permanently activated.
Factory setting rE: Start with
Y:ES
Confirm with
Restore changed settings to the fact-
ory settings.
The settings for initial start-up must
be configured.
1
Factory setting (may vary according to model)
Changing basic settings
1. Open the appliance door.
2. Press ⁠.
3. To open the basic settings, press
for 3 seconds.
a The display shows H:xx.
a The display shows ⁠.
4. Press repeatedly until
the display shows the required set-
ting.
5. Press or repeatedly until the
display shows the right value.
You can change several settings.
6. To save the settings, press
for 3 seconds.
7. Close the appliance door.
HomeConnect
HomeConnect
HomeConnect
This appliance is network-capable.
Connect your appliance to a mobile
device to control its functions via the
HomeConnect app.
The HomeConnect services are not
available in every country. The avail-
ability of the HomeConnect function
depends on the availability of
HomeConnect services in your coun-
try. You can find information about
this at: www.home-connect.com.
To be able to use HomeConnect,
you must first set up the connection
to the WLAN home network (Wi-Fi
1
)
and to the HomeConnect app.
¡ →"Connecting the appliance to
WLAN home network (Wi-Fi)",
Page40
The HomeConnect app guides you
through the entire login process. Fol-
low the instructions in the HomeCon-
nect app to configure the settings.
1
Wi-Fi is a registered trademark of the Wi-Fi Alliance.