D
David WilsonAug 8, 2025
How to prevent staples from jamming frequently in a Bosch STN150-18?
- MMichael TurnerAug 8, 2025
If staples jam frequently in your Bosch Nail Gun, use only recommended staples.
To Next PageTo Next PageHow to prevent staples from jamming frequently in a Bosch STN150-18?
If staples jam frequently in your Bosch Nail Gun, use only recommended staples.
What to do if the Bosch Nail Gun staple driving action seems slow or weak?
If the staple driving action of your Bosch Nail Gun seems slow or weak, you can try the following: * Increase the air pressure, but do not exceed 120 psi. * Use pneumatic tool lubricant. * Replace the bumper. * Check the hose for kinks. If the problem persists, follow the tool's recommendations or contact Bosch for replacement or repair.
How to adjust the depth when Bosch Nail Gun drives staples too deep?
If your Bosch Nail Gun drives staples too deep, reduce the air pressure, ensuring it's at least 60 psi. You can also use the “Depth of Drive Adjustment” feature or replace the bumper.
What to do if Bosch STN150-18 drives staples too shallow?
If your Bosch Nail Gun drives staples too shallow, increase the air pressure, ensuring it doesn't exceed 120 psi. Also, use the “Depth of Drive Adjustment” feature. Check the hose for any kinks and follow the tool's recommendations.
What to do if my Bosch Nail Gun operates, but no staple is driven?
If your Bosch Nail Gun operates but doesn't drive staples, try the following: * Clear any jams. * Clean and lubricate the tool. * Replace the follower spring. * Ensure you are using only recommended staples. * Reload the tool.
Why does my Bosch Nail Gun skip staples or have intermittent feed?
If your Bosch Nail Gun skips staples or has an intermittent feed, ensure you are using only recommended staples. Also, clean and lubricate the tool, and consider replacing the follower spring. If problems persist, contact Bosch for a replacement.
What to do if Bosch STN150-18 doesn't drive fully at faster nailing speeds?
If your Bosch Nail Gun drives staples properly during normal operation but not fully at faster nailing speeds, use the correct air hose and ensure you are using a correctly sized compressor for the number of tools used and the work rate.
General
