Robert Bosch Hausgeräte GmbH
Insert the power plug into a wall outlet.
► You can adjust the length of the power
cord by pushing it into or pulling it out of
the cord compartment.
► Take off the water tank (5).
► Remove the cup stand (7) and insert
it in the front of the appliance until you
hear an audible click.
Then clean the water tank thoroughly
under running water and ll it up to the
mark with fresh, cold water.
Do not use chemically softened water.
Remove the Service T DISC (6a) from
the compartment (6) behind the water
tank.
Replace the water tank by slanting it
slightly and returning it to its original
position until it clicks into place.
Turn the machine on by pressing the
ON / OFF switch (1).
The display elements (3) will light up
briey.
Select a large cup (minimum capacity
200 ml) and place it on the cup stand.
200 ml
To Next Page
Loading...
