Troubleshooting
The following table provides solutions for problems and
glitches that may arise as you use your TASSIMO machine.
problem persists after troubleshooting please contact TASSIMO
Customer Service at 1-877-TDISCS1 (1-877-834-7271).
! Note: If piercing unit is missing,
it may be purchased from TASSIMO
or Bosch Customer Service Department
at 1-877-TDISCS1 or only in the USA on www.tassimo.com.
Problem Possible cause Solution
no symbols light up.
There is no power supply.
properly plugged into the
power supply.
Machine brews but no
during the brewing process or
there is air in the system.
appropriate position in your
TASSIMO machine. Start a
cleaning process with the
Service T DISC.
O Automatic mode
remains in stand-by
mode.
No T DISC inserted.
inserted.
The barcode could not be
detected.
Clean the bar code reading
window and try again or
smooth the barcode on the
T DISC out with your thumb.
Use another T DISC.
If problems persist contact
TASSIMO Customer Service
Department at 1-877-
TDISCS1.
O Automatic mode
goes straight to
N Manual mode.
The barcode could not be
detected.
Clean the bar code reading
window.
Use another T DISC.
by holding down the start /stop
button.
More Customer Service information is available online at www.tassimo.com
To Next Page
Loading...
