EasyManua.ls Logo

Bosch TCA5201 - Appliance Controls; Control Panel Functions

Bosch TCA5201
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
11
TCA52 09/2007
en
This appliance can be adjusted for use
with different water hardness values (see
“Setting the water hardness“).
Switching on the appliance
●Pullenoughofthepowercordoutofthe
storage compartment and plug it into the
electrical socket.
●Removeandrinsethewatertank11
andllitwithfreshcoldwater.Donotll
above the “max“ mark.
●Replacethewatertank11 and push it
rmlydownintoplace.
●Fillthebeancontainerwithcoffeebeans.
●Setthepowerswitch1 to I. The stand-by
LED a lights red.
●Makesurethatthehotwater/steamdial6
is at O.
●Pressthestandbybutton a. The J
LEDashes.
Filling the system
Whenswitchedonforthersttime,the
waterpipesintheappliancemustbelled.
●Placeacupunderthenozzle8.
●Turnthedial6 to g/h. Water runs into
the cup.
As soon as J lights up, turn the dial 6
back to O.
●Thestandbybuttonawillnowash.The
appliance rinses and heats up.
The appliance is ready for use when the
stand-by LED a lights green.
i The appliance’s factory settings are
programmed for optimal performance.
Controls
1 Power switch
The power switch 1 on the rear of the
appliance switches the power supply on
and off.
When the power is switched on, the
standby LED a lights red.
The appliance is now in stand-by mode.
Warning
Do not press the power switch while the
appliance is operating. The appliance
should only be switched off when it is in
stand-by mode.
2 Stand-by button a
The stand-by button a switches the
appliance from stand-by mode to on.
When the stand-by button a is pressed, the
appliance heats up. The stand-by button a
asheswhiletheapplianceheatsupandis
rinsed. When the stand-by button a lights
green, the appliance is ready for operation.
The appliance will not be rinsed if:
it is still warm when switched on, or
coffee was not dispensed before it was
switched to stand-by mode.
Note: After 3 hours, the appliance
automatically switches to stand-by mode.
3 Coffee dispensing button 5
(mild coffee)
This button is used to dispense mild coffee.
When the button is pressed, the coffee is
ground, brewed and dispensed into the cup.
4 Coffee dispensing button K
(strong coffee)
This button is used to dispense strong
coffee.
When the button is pressed, the coffee is
ground, brewed and dispensed into the cup.
5 Steam generation button h
The steam button h generates steam for
foaming or warming.
6 Steam dispensing dial
Hot water or steam can be dispensed by
turning the dial to g or h. To dispense
steam, the steam generation button h
mustbepressedrst(see“Steamfor
frothing milk“).

Related product manuals