8
Before You Begin
Before You Begin
Tools and Parts Needed
▯ Phillips head screwdriver
▯ Slotted screwdriver 1/8" (3,5 mm)
▯ Adjustable wrench
▯ Tongue and groove pliers
▯ Socket or flat wrench 3/8” (10mm) or tongs
▯ Socket or flat wrench 7/8” (22mm) or tongs
▯ Drill with 5/16" (8mm) bit
▯ Pencil
▯ Tape measure
▯ Teflon tape or pipe-joint compound
Note: Additional materials may be necessary for
installation in solid surface countertops. Contact the
countertop manufacturer.
Parts Included
30”:
* Attached to the appliance.
36”:
* Attached to the appliance.
Removing Packaging
See the diagram on the packaging.
▯ If straps are present, cut the straps.
▯ Cut plastic down back of unit making sure not to cut
the unit.
▯ Remove plastic film.
▯ Lift the cardboard carton from the top of the range and
dispose of.
▯ Remove the corner posts, making sure that any other
packing materials running between the corner posts
are also removed.
▯ Remove all internal packaging and tape.
▯ The rear vent trim is nested in the styrofoam
packaging for shipping purposes. Do not throw away.
[[ [
[[ [
To Next Page
Loading...
Need help?
General
