Bosch TWK8613P - Parts and Operating Controls; Before Using for the First Time; Boiling Water

8
Robert Bosch Hausgeräte GmbH
en
Congratulations on purchasing this
Bosch appliance. You have acquired a
high-quality product that will bring you
a lot of enjoyment.
Parts and operating
controls
1 Kettle(withwaterlevelindicator)
2 Lid
3 Lidreleasebutton
4 ON/OFFOswitch
5 Temperatureindicator(illuminated)
6 +
–
button(temperaturesetting)
7 keep warmbutton
8 Limescalelter(removable)
9 Base
10 Cabletidy
Important: Usethekettle1onlywithits
includedbase9.
●Only ll the kettle with water.Milkand
instantbeverageswillburnanddamage
theappliance.Neveroperatethekettle
1withoutwateranddonotoverllit;
observetheminandmaxmarkings.If
thekettleistoofull,thewaterwillboil
over!
Before using
for the rst time
● Removeanystickersorlm.
● Unrolltherightamountofcablefromthe
cabletidy10andplugitin.
● Fillthekettle1withwater.Bringthewater
toaboilanddiscardit.Repeattheproce-
dure.Thiswillmakesurethatthekettleis
cleanfornormaluse.
● Whenthewatercomestoaboilforthe
rsttime,addatablespoonofwhite
vinegar.
Boiling water
● Fillthekettlewithfreshwaterthroughthe
spoutortheopenlid2(presslidrelease
button3).
● Checktheamountbyreadingthewater
levelindicatormarkingsminandmax.
● Closethelid2
untilitlocksandplacethe
kettle1onthebase9.
● PresstheOON/OFFswitch 4.The
kettleemitsasignal,andthefactory-set
temperature(100°C)lightsup.Thewater
isbeingheated.
● Bypressingbutton6+or–youcanset
thetemperaturetoca.70°C,ca.80°C,
ca.90°Corca.100°C.
● Whenthewaterhasreachedtheselected
temperature,thekettlewillswitchoff
automatically,thetemperatureindicator5
goesoff,andasignalsounds.
Note: Theselectedtemperaturecanbe
changedatanytimewhilethekettleis
heatingup.Whilethekettleheatsup,the
currenttemperaturelightsup;thepreset
temperatureashesuntilithasbeen
reached.
Ifthetemperaturecannotbeset,thisindi-
catesthatthewaterinthekettleishotter
thanthedesiredtemperature.Thecurrent
temperaturewilllightup.
Youcanturnoffthekettleatanytimeby
pressingtheOON/OFFswitch4again.
Warning:Ifyouremovethekettle1from
thebaseandreplaceitbeforetheheating
processisover,thekettlewillnotcontinue
toheatthewater.Theselectedsettingswill
belost(resettofactorysetting).
TWK86_MASTER_SLIM.indd 8 23.10.2013 09:59:26