Bosch WAN280L5SN - Inserting Liquid Detergent Measuring Aid; Adding Detergent and Care Product; Starting the Programme; Changing Programme End Time

en operation
28
13.5 Inserting the measuring
aid for liquid detergent
If you order the measuring aid as an
accessory, you must use the measur-
ing aid.
1. Pull out the detergent drawer.
2. Press down on the insert and re-
move the detergent drawer.
3. Insert the measuring aid.
4. Insert the detergent drawer.
13.6 Adding detergent and
care product
Notes
¡ Do not use the measuring aid for
liquid detergent for gel detergents,
washing powder, or if Prewash or
"Ready in" time are activated.
¡ Observe the information about de-
tergents and care products
→Page27.
1. Pull out the detergent drawer.
2. Pour in detergent.
→"Detergent drawer", Page17
3. If required, add the care product.
4. Push in the detergent drawer.
13.7 Starting the programme
Requirement:A programme is set.
→"Setting a programme", Page27
▶ Press ⁠ .
a The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a The display shows the programme
duration or the programme end
time.
a After the programme has ended,
the display shows: "End".
13.8 Changing the activated
programme end time
You can repeatedly change the set
and activated programme end time
before starting the programme.
Requirements
¡ The programme is set.
→"Setting a programme", Page27
¡ The programme end time is set
and activated.
→"Buttons", Page22
1. Press ⁠ .
The activated programme end time
is paused.
2. Press ⁠ until the display shows
the required programme end time.
3. Press ⁠ .
The changed programme end time
is activated.