Bosch WAW28768SN - Display Panel

Getting to know the appliance en
27
Display panel
Default programme settings:
( Temperature in °C
Ž - 90 (Ž = cold)
0
■ Spin speed in rpm,
$, 0 - 1600*;
* Max. spin speed, depending
on the selected programme
and model,
■ 0 = no spin cycle, draining only
~ Page 36,
■ $ = Rinse Stop ~ Page 36
8
■ Ready in
e.g. 2:30;
Programme duration depends
on the programme selection in
h:min (hours:minutes)
■ End time preselection
1 - 24 h;
Programme ends after ... h
(h = hours),
■ Load recommendation
e.g. kg 8*;
* depending on the selected
programme
@ Information on energy and water
consumption: ~ Page 13
■ X { { { { {
Water consumption display,
■ þ { { { { {
Energy consumption display
#

Further information
Ø Active Oxygen (Ø) ~ Page 37
Programme progress:
Ø Active oxygen phase
! Prewash
N Wash
õ Rinse
0 Spin
- 0 - Programme end
$ Programme end during Rinse Stop
- P - Pause, e.g. to reload laundry
Loading door:
ÿ
lights up
The washing machine door can be
opened.
ÿ
flashes
When the programme has started:
The washing machine door is not
closed properly.
Tap:
r
lights up
Tap not turned on, no water
pressure
r
flashes
Water pressure too low (may
increase the programme duration)
Childproof lock: ~ Page 41
E
lights up
Childproof lock activated
E
flashes
Childproof lock activated,
programme selector adjusted
Foam detection function:
Å
lights up
~ Page 40
Fault display:
E: - - ~ Page 49
Signal setting:
0 - 4 ~ Page 43
Automatic switch-off of the appliance:
On OFF ~ Page 13, ~ Page 43