Bosch WAY28540EE - Page 39

39
Display panel/indi-
cator lights do not
function while the
appliance is running.
–Power failure?
– Fuse tripped? Switch on/replace fuse.
– If the fault occurs repeatedly, call customer service. ~ Page 40
The programme
takes longer than
usual.
– Not a fault – unbalanced load detection system adjusts imbal-
ance by repeatedly distributing the washing.
– Not a fault – foam detection system active – several rinse cycles
are switched on.
Detergent residue
on the washing.
– Occasionally phosphate-free detergents contain water-insoluble
residue.
– Select
O (Rinse/Freshen up) or brush the laundry after washing.
In the pause status
inicio/pausa carga
(Start/Reload) A
flashes very quickly
and a signal sounds.
– Water level too high. Washing cannot be reloaded. Immediately
close washing machine door.
– Select inicio/pausa carga (Start/Reload) A to continue the pro-
gramme.
If a fault cannot be rectified (switching the machine on and off) or a repair is required:
– Switch off the appliance and pull out the mains plug.
– Turn off the tap and call customer service. ~ Page 40
Faults Cause/Remedy