48
Information on the display panel
Display Cause/Remedy
The door cannot be
locked, please open
the door again, then
close it and select
"start/pause".
– Washing may be caught. Please open and close washing
machine door again and select Start/Reload
A.
– If required, shut washing machine door or remove washing
and shut again.
– If required, switch appliance off and on again; set programme
and make individual settings; start programme.
Please re-fill i-DOS
i/
w, i-DOS w container
Level i-DOS container below minimum. Top up ~ Page 33
i-DOS
i/w, i-DOS w
error; deactivate
i-DOS i/w, i-DOS w
Set i-DOS i/w, i-DOS w to off.
Call customer service. Appliance can continue to be operated
with manual dosage. ~ Page 35
Please close
detergent drawer.
Push in detergent drawer correctly.
Please open tap – Turn on tap fully.
– Supply hose kinked/jammed.
– Water pressure too low. Clean the filter. ~ Page 46
Please clean pump – Drain pump blocked. Clean the drain pump.
– The water drainage pipe/drain hose is blocked. Clean the
drainage hose on the siphon. ~ Page 45
Pause: Reload is not
possible
Water level or temperature is too high.
Select Start/Reload
A to continue the programme.
Door cannot be
unlocked: Water level
or temperature is too
high
Water level or temperature is too high.
Select Start/Reload
A to continue the programme.
AquaStop has been
activated!
Please call customer
service
not applicable without AquaStop
Water in the base pan, appliance leaking.
Call customer service! ~ Page 51
Auto power-off in ...
seconds,
Appliance automatically switches off after ... seconds if it is not
operated for a prolonged period. In order to cancel the
programme, press any button. ~ Page 39
Water cooling To protect the wastewater pipes, the hot detergent solution is
cooled before being drained.
Other displays
Error E: XXX
Switch off appliance, wait 5 seconds and switch on again. If the
display is indicated again, call customer service. ~ Page 51
To Next Page
Loading...
