Bosch WDU8H542ES - Activating Wi-Fi on the Appliance; Deactivating Wi-Fi on the Appliance; Resetting the Appliance Network Settings; Remote Start

HomeConnect en
37
3. Once your appliance is displayed
in the HomeConnect app, carry
out the last steps in the
HomeConnect app.
a If the display shows "con" , the ap-
pliance is connected to the
HomeConnect app.
16.4 Activating Wi-Fi on the
appliance
Note:When Wi-Fi is activated, the en-
ergy consumption increases in com-
parison to the values specified in the
consumption value table.
1. Press and hold ⁠ for approx. 3
seconds.
2. Set the programme to position 4.
a The display shows "Con".
3. Press ⁠ repeatedly until the dis-
play shows "on".
a Wi-Fi is activated.
16.5 Deactivating Wi-Fi on the
appliance
1. Press and hold ⁠ for at least
threeseconds.
2. Set the programme to position 4.
a The display shows "Con".
3. Press ⁠ repeatedly until the dis-
play shows "oFF".
a Wi-Fi is deactivated.
Note:The connection is automatically
re-established when the Wi-Fi is
switched back on.
16.6 Resetting the appliance
network settings
1. Press and hold ⁠ for at least
3seconds.
2. Set the programme to position5.
a The display shows "rES".
3. Press ⁠ .
a The display shows "YES" .
4. Press ⁠ .
a The network settings are reset.
a If End is shown on the display, the
network settings are reset.
16.7 Remote start
Enable the appliance for remote start
via the HomeConnect app.
Activating remote start
Notes
¡ Remote start is deactivated for
safety reasons in the following
circumstances:
– Open the appliance door.
– Press ⁠ .
– Press ⁠ .
– Switch off the appliance.
– Following a power cut.
¡ For safety reasons, remote start
cannot be activated if the appli-
ance door is open.
Requirements
¡ The appliance is connected to your
Wi-Fi home network.
¡ The appliance is connected to the
HomeConnect app.
¡ A programme is selected.
▶ Press ⁠ .
If you press and hold the button
for at least 3seconds, the
HomeConnect menu opens.
If you briefly press the button, the
appliance is enabled for remote
start via the HomeConnect app.
If you open the appliance door, the
function is automatically deactiv-
ated.
a ⁠ lights up.
Note:To deactivate the function,
press ⁠ .