operation en
33
3. Fold the measuring aid down and
click it into place.
4. Push in the detergent drawer.
14.8 Adding detergent and
care product
Notes
¡ Do not use the measuring aid for
liquid detergent for gel detergents,
washing powder, or if Prewash or
"Ready in" time are activated.
¡ Observe the information about de-
tergents and care products
→Page31.
1. Pull out the detergent drawer.
2. Pour in detergent.
→"Detergent drawer", Page18
3. If required, add the care product.
4. Push in the detergent drawer.
14.9 Starting the programme
Note:If you want to change the time
until the programme ends, set the
"Ready in" time first.
1. Press .
a The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a The display shows either the pro-
gramme duration or the "Ready in"
time.
a After the programme has ended,
the display shows: End.
2. If is selected, the laundry is not
spun and the water is drained after
rinsing.
Notes
¡ If the laundry is not removed, the
Anti-Crease programme starts after
15 minutes. The programme takes
around 30 minutes. The display
shows 00:00 and appears.
Press anywhere on the display to
cancel the Anti-Crease programme
and to remove the laundry.
¡ If "Hot" appears, the appliance
cools the laundry.
When "Hot" goes out, the laundry
has cooled down.
14.10 Soaking laundry
Note:No additional detergent is re-
quired. The washing solution is then
used for washing.
1. Start the programme.
2. To pause the programme, after ap-
prox. 10 minutes, press .
3. To resume the programme, after
the desired soaking time, press
.
14.11 Adding laundry
1. Press .
During the washing cycle, the ap-
pliance pauses.
During the drying cycle, the appli-
ance checks whether it is possible
to add laundry.
Note:If appears, it is not pos-
sible to add laundry.
When goes out, it is possible to
add laundry.
2. Open the appliance door.
3. Add or remove laundry.
4. Close the appliance door.
To Next Page
Loading...
