EasyManua.ls Logo

Bosch WTE84105GB Installation Instructions, Instructions for Use, Programme Table - Drying Operations; Emptying Condensation; Cleaning the Fluff Filter; Switching off the Dryer

Bosch WTE84105GB Installation Instructions, Instructions for Use, Programme Table
8 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3 4
Emptying condensation
Empty container after each drying operation!
1. Pull out condensation container keeping it horizontal.
2. Pour out condensation.
3. Always push container in fully until it clicks into place.
If Container flashes in the display panel a What to do if..., Page 10.
Cleaning the fluff filter
Clean the fluff filter after each drying operation.
1. Open the door, remove fluff from door/door area.
2. Pull out and fold open the fluff filter.
3. Remove the fluff (by wiping the filter with your hand).
If the fluff filter is very dirty or blocked, rinse with warm water and dry
thoroughly.
4. Close and reinsert the fluff filter.
Switching off the dryer
Turn the programme selector to Off.
Do not leave laundry in the dryer.
Removing the laundry
The automatic anti-crease function causes the drum to move at specific intervals, the washing remains
loose and fluffy for an hour (two hours if the additional Reduced Ironing function is also selected-
depending on model).
... and adapt to individual requirements
Inspecting the
dryer
Sorting and loading laundry

Selecting and adjusting the programme
Drying
Condensation container
Control panel
ʋ
ʋ
Select the drying programme ...
Press the Start/Stop button
1
2
3
Connecting the
mains plug
Drying
(
'ca&
)c
a
a
a
a
a
a
a
a
a
a
a
a
Drum
All buttons are sensitive and only
need to be touched lightly.
Only operate the dryer with
the fluff filter inserted!
Air inlet
Fluff filter
Drum interior light
(depending on model)
Maintenance
flap
Programme end as soon as the light comes on
Interrupt programme removing or adding laundry.
The drying cycle can be interrupted for a brief period so that laundry may be added or removed.
The programme selected must then be resumed and completed.
Never switch the dryer off before the drying process has ended.
Drum and door may be hot!
1. Open door, the drying process is interrupted.
2. Load or remove laundry and close door.
3. If required, select a new programme and additional functions.
4. Press the Start/Stop button.
ʋ
ʋ
ʋ
ʋ
ʋ
ʋ
ʋ
ʋ
ʋ
ʋ
ʋ
ʋ
a
ˎ&'

Related product manuals