Bosch WTG864H2 - Starting the Programme; Changing the Activated Ready In Time; Adding Laundry; Cancelling the Programme

en operation
28
12.4 Starting the programme
Requirement:A programme is set.
→"Setting a programme", Page27
▶ Press Start/Nachlegen .
a The display shows the programme
duration or the "Ready in" time.
a After the programme has ended,
the display shows: "End" .
12.5 Changing the activated
"Ready in" time
If you have set and activated a
"Ready in" time for a delayed pro-
gramme start, you can change the
"Ready in" time again before the pro-
gramme starts.
Requirements
¡ The programme is set.
→"Setting a programme", Page27
¡ The "Ready in" time is set and ac-
tivated.
→"Buttons", Page22
1. Press Start/Nachlegen .
The activated "Ready in" time is
paused.
2. Press Fertig in repeatedly until
the display indicates the desired
"Ready in" time.
3. Press Start/Nachlegen .
The changed "Ready in" time is ac-
tivated.
12.6 Adding laundry
After the programme starts, you can
remove or add laundry at any time.
Requirement:A programme has
started.
→"Starting the programme",
Page28
1. Press Start/Nachlegen .
2. Open the door.
3. Add or remove laundry.
4. Close the door.
5. Press Start/Nachlegen .
12.7 Cancelling the pro-
gramme
1. Press Start/Nachlegen .
2. Open the appliance door.
3. Remove the laundry.
→"Unloading the laundry",
Page28
12.8 Unloading the laundry
1. Open the door.
2. Remove the laundry from the
drum.
12.9 Switching off the appli-
ance
▶ Turn the programme selector to
Aus .
12.10 Fluff filter
During drying, fluff from the laundry is
collected in the fluff filter. The fluff fil-
ter protects the appliance from fluff.
Cleaning the fluff filter
If the drying programme has finished
or the display shows a notification
while the appliance is in operation,
clean the fluff filter.
Note:If you do not clean the appli-
ance as described, the appliance's
functionality may be impaired.
Requirements
¡ The display shows the following
after drying: "End"
¡ or during operation: ⁠ .
1. Open the door.