Bosch WTW87568SN - Information on the Display

Information on the display en
33
Y Information on the display
Information on the display
--------
Note: If you cannot rectify the fault yourself by turning the appliance off and then on
again, please contact our after-sales service.~ Page 39
Faults Cause/remedy
ð on the display and
drying has stopped.
■ Empty the condensation container and reinsert it.~ Page 28
Press (Start/Pause) A.
■ Once you have installed the optional drain hose*, make sure that it:
Is correctly connected
Is free of kinks
Is not blocked or clogged, e.g. with deposits
é on the display. Remove the fluff.~ Page 29
Press (Start/Pause) A.
ó on the display. Not a fault. The heat exchanger is being cleaned automatically. Do not pull out
the condensation container while this is displayed.
The display goes out and
(Start/Pause) A
flashes.
Not a fault. Energy saving mode is active .
* Depending on how the appliance is equipped or the available accessory