en Transporting the appliance
36
3. Push the condensation container
back into the appliance until you feel
it lock into place.
4. Press # to switch on the appliance.
5. Select any programme.
6. Press (Start/Pause) A.
7. Wait for 5 minutes.
The condensation water will be drained.
8. Empty the condensation container
again.
9. Switch off the appliance.
10.Disconnect the appliance's mains
plug from the power supply.
The appliance is now ready to be
transported.
Caution!
Risk of material damage/damage to the
appliance
■ Despite draining, there will always be
some residual water in the
appliance. Any residual water may
leak out and cause material
damage.
The appliance should therefore be
transported upright.
Risk of material damage/damage to the appliance
■ The appliance contains refrigerant
and may be damaged if it is
operated immediately after
transportation.
Allow the appliance to rest for two
hours before initial use.
To Next Page
Loading...
