• toggle yellow light on/off, initiated by command from shell (option 1.):
o toggle
• enable/disable sensor, initiated by command from shell (option 1.):
o sensor NOISE TRUE or sensor NOISE TRUE: to enable/disable the noise sensor.
To tkae effect an restart is required. Enabling/disabling the sensor is written
to the config file on the WIFI chip
• restart XDK from C8Y, issued by option in drop-down menue (option 3.):
o select XD: device in C8Y cockpit and execute "Restart device" from
dropdown-menue "More"
• toggle yellow light on/off, initiated from message (any text) widget (option 2.):
o add "Message Widget" to dashboard, use your connected XDK device as
destination and send any text to this XDK
• stop/start publishing measurements:
o stop
o start
12 View events sent from device
You can view the last events transmitted form the XDK by accessing the app Device
management and follow: Device Management>Devices>All Devices. Then choose your XDK
and select the Events template
You can see events like::
1. XDK started!
2. Publish stopped!
3. Publish stated!
13 Buttons
The buttons have following on the XDK have the following functions:
• Button one dot: stop/start sending measurements to Cumulocity
• Button two dots:
o if pressed for longer than 3 seconds resets boot status stored on device
flash to "NOT_IN_BOOT_PROCESS"
o if pressed shortly prints the configuration currently stored in
the config.txt file on the filesystem of the WIFI chip
o if pressed during the startup process of the XDK the configuration stored
on the WIFI chip is deleted
14 Detailed configuration
The C8Y Agent for XDK sends the following sensor measurements to C8Y:
To Next Page
Loading...