Bose 151 User Manual

Decide where you
want the speakers
For best results, mount both speakers on the
same wall, facing the listening area Make
sure they
do not face each other (Outdoors,
if you are not using an existing wall, con-
sider the length of your listening area as
your "wall ")
Measure the length of the wall and
divide
that length by six Place one speaker one-
sixth of the length from the left end of the
wall Place the other speaker one-sixth the
length from the right end (see Figure
1)
If you place your 151 ® speakers outdoors,
you will
probably connect them to an
amplifier or receiver that is inside
Note: You may want to consultan electrical
installer who can route wires underground
or through walls ifnecessary
Whether you mount them inside or out,
consider the following
• Measure the length of speaker
cords you
need to
connect each speaker to your
receiver or amplifier To determine the
wire
gauge you will need, refer to the wire
gauge recommendations under "Techni-
cal information" on
page 11
• It is important that the speaker cord not
be
tripped over, pinched, or pulled
Determine the best route to protect the
wire
... - - - - - - - - - - - - - - - - - - - Length of wall - - - - - - - - - - - - - - - - - .....
Figure 1
Place one speaker one-sixth of the way from each end of the wall
4

Bose 151 Specifications

General

Type	In-wall/On-wall/In-ceiling speakers
Dimensions (WxDxH)	318 x 152 x 114 mm
Speaker type	2-way
Tweeter diameter	64 mm
Audio output channels	2.0 channels
RMS rated power	- W
Product color	White
Package weight	5100 g

Weight and Dimensions

Weight	4300 g