7
DISASSEMBLY PROCEDURES
1. Grille Removal
1.1 Remove the grille by pulling on the ends with your fingers, or pry carefully with a non-
metallic object.
Note: The grille is made entirely of metal. Do not try to remove the grille by pulling on the
plastic (polypropylene) speaker enclosure.
2. Enclosure Dissassembly
2.1 To disassemble the enclosure, place the unit on a flat soft surface grille side down. Remove
the 8 screws identified below.
Note: The unit is press-fit together. All parts of the unit must be in place prior to replacing the 8
screws.
2.2 With the unit face down, gently pull up on the rear enclosure. Be careful not to lift the unit
too high, as the Twiddler
®
speakers are wired to the rear enclosure. Lay the rear enclosure on
its side to expose the inside of the unit and the Twiddler speakers as seen below.
To Next Page
Loading...
