9
DISASSEMBLY PROCEDURES
4. Twiddler
®
Removal
4.1 Perform procedure 1.
4.2 Make a note of the wiring configuration. Lift the Twiddler speakers out and cut the wires as
close to the wire terminals as possible.
5. Twiddler Replacement
5.1 Set the center Twiddler speaker in place first, then the two outer Twiddler speakers. Take
care to lower the outer Twiddler speakers straight down when setting them in place, this will
ensure that the gasket seats in the correct location.
5.2 Wire the Twiddler speakers as shown below.
Wiring Diagram
Terminal 1 (+)
Terminal 2 (-)
To Next Page
Loading...
