10
TEST PROCEDURES
1. AM Tuner Adjustment Procedure
Note: Refer to the antenna placement
diagram Figure 1.
1.1 Connect an AM signal generator to an
AM loop antenna. Set the frequency ac-
cording to the AM alignment procedure
listed below.
1.2 Connect a voltmeter to the tape output
jacks on the rear panel.
1.3 Refer to the adjustment location chart
(Figure 2.) for the location of the tuning
coils called out in the AM alignment proce-
dure.
2. FM/MPX Tuner Adjustment
2.1 Connect an FM signal generator to the
antenna terminals on the rear panel.
2.2 Connect a voltmeter to the tape output
jacks on the rear panel.
2.3 Refer to the adjustment location chart
(Figure 2.) for the location of the tuning
coils called out in the FM/MPX alignment
procedure.
2.4 Perform the tests listed on the next
page for the FM and MPX sections.
AM Alignment Procedure
,,,
,,,
,,,
,,,
,,,
,,,
STANDARD
SIGNAL
GENERATOR
STANDARD
SIGNAL
GENERATOR
60cm
TEST
LOOP
BAR
ANTENNA
(PLAN VIEW)
(SIDE VIEW)
,
,
,
Figure 1. Antenna Placement Diagram
To Next Page
Loading...
