Bose L1 1S - Page 63

63
Molex Connector
Rear View
12
34
4. L1
®
Model 1S Line Array Test Cables
These two cables will allow you to test the upper line array section without an L1 Model 1S
power stand. Use these cables for the line array test procedures in this service manual.
Line Array Test Cable
Parts needed:
1 - 4 pin Molex male connector, Molex part number 39-01-2041
4 - Molex crimp-on pins for above connector, Molex part number 39-00-0041 (M)
1 - dual banana jack
12 feet of 16 or 18AWG twisted pair wire
Cut the 12 foot length of twisted pair wire in half. Strip all of the wires back
about 1/4 inch. Crimp the molex pins onto the wires. The positive (+) side of
the twisted pair wires will go into pins 2 and 4 of the Molex connector. The
negative (-) side of the twisted pair wires will go into pins 1 and 3 of the Molex
connector. Connect the wires that go to pins 2 and 4 of the Molex connector to
the positive (+) side of the dual banana jack. Connect the wires that go to pins
1 and 3 of the Molex connector to the negative (-) side of the dual banana
jack.
Appendix