If you connected your TV to the VS-2 using an S-Video cable, you can use only an S-Video or Composite con-
nection for your A/V devices even though a device m
ay have HDMI or component video output connectors.
1. Look at th
e rear panel of each A/V device to determine what type of video output connectors it has.
2. In t
he following table, choose the type of video connector that provides the highest possible video quality.
We recommend using an S-Video connection if it is available. Place a check mark in the table for the connec-
tor type used for each of your A/V devices.
If any of your A/V devices do not have an S-Video connector, you can use a
Composite connector. Remember, the VS-2 converts this up to S-Video format.
Video
Quality
Video
Connector VCR CBL•SAT
AUX
(Other)
Good
S-Video
Standard Composite
Connecting your A/V devices to the VS-2
1. Plug one end of the video cable into the appropriate video output connector on the rear of your A/V
device.
2. Plug the other end of the video cable into the appropriate Video INPUT connector(s) on the VS-2.
3. Re
fer to your LIFESTYLE
®
system installation guide for information on making audio connections.
To Next Page
Loading...
