Boss Design Tauro - User Manual

To Next Page

Seat Height

Seat Depth

Arm Height

Lift the paddle located under the right hand side of your seat,

whilst lifting your weight out of the chair, allowing the seat to

rise to the desired position. To lower the seat, lift the paddle

again leaving your body weight on the seat. The seat will lock

at the height at which the handle is released.

Press the buttons on the outside of the arm risers to raise

and lower the arms. Ensure that both arm pads are the same

height and release the button to lock into position. Set the

arm height so that your forearms are set at 90º when your

shoulders are relaxed. The height adjustable arm will locate

in one of eleven positions.

Whilst seated, pull out the button on the left hand side

of the seat and slide the seat into your desired position.

Release the button to lock the seat. There is 65mm of

movement in the seat slide which is a standard feature.

Tauro User Instructions

TAU/1

Need help?

Do you have a question about the Boss Design Tauro and is the answer not in the manual?

Summary

Lift the paddle to adjust seat height. Lower by lifting paddle with weight on seat.

Press buttons to raise/lower arms. Ensure pads match height for 90° forearm angle.

Pull button to slide seat. Release to lock. Offers 65mm of movement.

Reach behind backrest to slide lumbar support up or down for optimal comfort.

Press button on back underside to raise/lower back for lumbar alignment.

Paddle adjusts recline positions. Outward locks upright, inward increases recline.

Pull bar from under seat. Rotate anti-clockwise to reduce tension, clockwise to increase.

General